Q150 150MM BUS BAR AND CABLE AC SPLIT CORE CT CURRENT PROBE CLAMP
The model Q150 current probe can be used in large current situation and cooperate to cable fault tester and cable identification device, used for cable test work.
FEATURES
- This product can be used in large current situation; also can cooperate to cable fault tester and cable identification device, used for cable test work.
- Holding wire diameter: φ150mm
- Dimension: 229mm×364mm×44mm
- Load capacity: ma output ≤4Ω, 1A output 0.1Ω, 5A output 2.5VA
- Installation: clamp type
- Output mode: lead output
PARAMETERS
| Electrical parameters |
| Ratio |
1000: 1 or 2000:1 (customized) |
| Accuracy class |
0.2%, 0.5%, 1% |
| Primary current |
0 - 5000A AC |
| Secondary current |
0 - 5A AC (customized) |
| Max. Cont. Input current |
6000A |
| Over voltage category |
CAT III 600 V |
| Output signal (AC current) |
500mA,1A,5A AC at nominal input current |
| Output signal (AC voltage) |
333mV,500mV,1V,5V AC at nominal input current |
| Frequency range |
40Hz-2000Hz |
| Dielectric strength |
3KV 50Hz/60Hz at 1 minute |
| Temperature range |
-20°C to +55°C |
| Output |
2.5 meter cable with D01 connector |
| Max. voltage not insulated conductors |
600 V |
| Standard |
EN 61010-1, EN 61010-2-032, IEC60044-1 |
| Installation |
Clamp type |
| Output mode |
Lead output(2.5m) |
| Mechanical parameters |
| Dimensions (L x W x H) (mm) |
229x364x 44 |
| Weight (g) |
1700 |
| Holding wire diameter (mm) |
φ150 |
| Max. jaw opening (mm) |
150 |
| Jaw color |
White |
| Material |
PC+ABS+Polycarbonate, UL94 V0 |
